See the live Australia fire map

Fire near Isaac (QLD)

Satellite detection (unconfirmed)

Lower intensity fire near Isaac (QLD), first detected 15 Nov 2026 and last seen . It has been picked up by 13 satellite detections, peaking at 18 MW.

Status
Recent
First detected
15 Nov 2026, 06:18 UTC
Last detected
15 Nov 2026, 15:42 UTC
Duration
9.4 h
Detections
13
Peak intensity (FRP)
18 MW
Peaked at
15 Nov, 06:28 UTC
Fire footprint
1.2 km × 2.3 km
Detection sources
13 DEA
State
QLD
Confirmation
Satellite only
Data source
DEA

Satellite detections — 13 hot spots

This fire is 13 satellite heat detections merged into one event across 1 day (13 DEA). Each row is one satellite pass over a burning pixel — all of them are plotted on the map above, where the most recent detections are ringed in white. Tap any point on the map for its time and intensity, or switch on the heat map (top-right) to see where activity concentrated.

Time (UTC)IntensitySourceLatitude, Longitude
15 Nov 2026, 15:42 2 MW DEA -22.094, 148.645
15 Nov 2026, 15:42 2 MW DEA -22.094, 148.645
15 Nov 2026, 15:35 — DEA -22.091, 148.642
15 Nov 2026, 14:45 2 MW DEA -22.092, 148.645
15 Nov 2026, 14:45 2 MW DEA -22.093, 148.650
15 Nov 2026, 14:45 2 MW DEA -22.092, 148.645
15 Nov 2026, 14:45 2 MW DEA -22.093, 148.650
15 Nov 2026, 06:28 15 MW DEA -22.104, 148.646
15 Nov 2026, 06:28 18 MW DEA -22.093, 148.644
15 Nov 2026, 06:28 14 MW DEA -22.103, 148.639
15 Nov 2026, 06:18 9 MW DEA -22.101, 148.641
15 Nov 2026, 06:18 8 MW DEA -22.101, 148.651
15 Nov 2026, 06:18 10 MW DEA -22.111, 148.641

Other fires nearby

This is an unconfirmed satellite detection, not an official warning. Satellites detect heat, which may be a bushfire, a hazard-reduction burn, or industrial activity. Always check the official source and, in an emergency, call 000.

Official information for QLD: Queensland Fire Department.

Frequently asked questions

Is this a real bushfire?

Unless it is marked as matched to an official incident, this is an unconfirmed satellite detection. Satellites detect heat, which can be a bushfire, a hazard-reduction burn or an industrial source. Check the official warnings for confirmation.

What does “peak intensity (FRP)” mean?

FRP (fire radiative power, in megawatts) is how much heat the fire was giving off when a satellite detected it. The peak is the highest reading across all detections — a rough guide to how intense the fire has been.

Why are several nearby detections shown as one fire?

We group satellite detections that are close together in space and time into a single fire event, so a fire front seen across multiple passes appears as one fire rather than scattered dots.

How do I get the official information for this fire?

Follow the official source link on this page (where available) and your state fire agency. In an emergency call 000.