See the live Australia fire map

Fire near Cook (QLD)

Satellite detection (unconfirmed)

Lower intensity fire near Cook (QLD), first detected 15 Nov 2026 and last seen . It has been picked up by 10 satellite detections, peaking at 26 MW.

Status
Recent
First detected
15 Nov 2026, 03:23 UTC
Last detected
15 Nov 2026, 04:29 UTC
Duration
1.1 h
Detections
10
Peak intensity (FRP)
26 MW
Peaked at
15 Nov, 03:35 UTC
Fire footprint
0.5 km × 0.8 km
Detection sources
10 DEA
State
QLD
Confirmation
Satellite only
Data source
DEA

Satellite detections — 10 hot spots

This fire is 10 satellite heat detections merged into one event across 1 day (10 DEA). Each row is one satellite pass over a burning pixel — all of them are plotted on the map above, where the most recent detections are ringed in white. Tap any point on the map for its time and intensity, or switch on the heat map (top-right) to see where activity concentrated.

Time (UTC)IntensitySourceLatitude, Longitude
15 Nov 2026, 04:29 — DEA -13.829, 142.361
15 Nov 2026, 04:29 — DEA -13.829, 142.364
15 Nov 2026, 04:29 — DEA -13.833, 142.361
15 Nov 2026, 04:29 — DEA -13.833, 142.364
15 Nov 2026, 04:29 — DEA -13.837, 142.361
15 Nov 2026, 03:35 26 MW DEA -13.834, 142.363
15 Nov 2026, 03:35 25 MW DEA -13.836, 142.366
15 Nov 2026, 03:35 26 MW DEA -13.834, 142.363
15 Nov 2026, 03:23 — DEA -13.833, 142.361
15 Nov 2026, 03:23 — DEA -13.833, 142.364

Other fires nearby

This is an unconfirmed satellite detection, not an official warning. Satellites detect heat, which may be a bushfire, a hazard-reduction burn, or industrial activity. Always check the official source and, in an emergency, call 000.

Official information for QLD: Queensland Fire Department.

Frequently asked questions

Is this a real bushfire?

Unless it is marked as matched to an official incident, this is an unconfirmed satellite detection. Satellites detect heat, which can be a bushfire, a hazard-reduction burn or an industrial source. Check the official warnings for confirmation.

What does “peak intensity (FRP)” mean?

FRP (fire radiative power, in megawatts) is how much heat the fire was giving off when a satellite detected it. The peak is the highest reading across all detections — a rough guide to how intense the fire has been.

Why are several nearby detections shown as one fire?

We group satellite detections that are close together in space and time into a single fire event, so a fire front seen across multiple passes appears as one fire rather than scattered dots.

How do I get the official information for this fire?

Follow the official source link on this page (where available) and your state fire agency. In an emergency call 000.