See the live Australia fire map

Fire near New South Wales (NSW)

Near an official incident

Official warning: Advice (Under control) — NSW RFS · official source

Lower intensity fire near New South Wales (NSW), first detected 18 Nov 2026 and last seen . It has been picked up by 0 satellite detections, peaking at 0 MW.

Status
Active
First detected
18 Nov 2026, 00:30 UTC
Last detected
18 Nov 2026, 00:30 UTC
Duration
0 h
Detections
0
Peak intensity (FRP)
0 MW
Fire footprint
6.1 km × 5.8 km
Burnt area (perimeter)
101 ha
State
NSW
Confirmation
Official
Data source
SATELLITE

Burnt area & fire boundaries

Official mapped boundaries overlapping this fire — the ground it has burned. These are drawn on the map above (the shaded red areas). Boundaries are captured periodically, so the true edge may have moved since.

  • H POTS FIRE, CESSNOCK 101 ha · 6.1 km perimeter · NSW National Parks and Wildlife Service · mapped

Official incident details

Warning level
Advice
Type
Bush Fire
Status
Under control
Reported size
101 ha
Agency
NSW RFS
Updated
Official advice (verbatim):
ALERT LEVEL: Advice
LOCATION: MCFARLANE ST, CESSNOCK 2325
COUNCIL AREA: Cessnock
STATUS: Under control
TYPE: Bush Fire
FIRE: Yes
SIZE: 101 ha
RESPONSIBLE AGENCY: NSW National Parks and Wildlife Service
UPDATED: 17 Nov 2026 22:54

Official source ↗

Crew, appliance and aircraft numbers aren't published in Australia's open incident feeds, so we can't list firefighters here — follow the official source above for operational detail.

Other fires nearby

This satellite fire has been matched to an official incident (see the warning above). The official advice is the authority — always follow your fire agency, and in an emergency call 000.

Official information for NSW: NSW Rural Fire Service.

Frequently asked questions

Is this a real bushfire?

Unless it is marked as matched to an official incident, this is an unconfirmed satellite detection. Satellites detect heat, which can be a bushfire, a hazard-reduction burn or an industrial source. Check the official warnings for confirmation.

What does “peak intensity (FRP)” mean?

FRP (fire radiative power, in megawatts) is how much heat the fire was giving off when a satellite detected it. The peak is the highest reading across all detections — a rough guide to how intense the fire has been.

Why are several nearby detections shown as one fire?

We group satellite detections that are close together in space and time into a single fire event, so a fire front seen across multiple passes appears as one fire rather than scattered dots.

How do I get the official information for this fire?

Follow the official source link on this page (where available) and your state fire agency. In an emergency call 000.