Fire near Tenterfield (NSW)
Near an official incident
Lower intensity fire near Tenterfield (NSW), first detected 1 Oct 2026 and last seen . It has been picked up by 3 satellite detections, peaking at 3 MW.
- Status
- Active
- First detected
- 1 Oct 2026, 03:31 UTC
- Last detected
- 1 Oct 2026, 03:32 UTC
- Duration
- 0 h
- Detections
- 3
- Peak intensity (FRP)
- 3 MW
- Peaked at
- 1 Oct, 03:31 UTC
- Burnt area (perimeter)
- 2,589 ha
- Detection sources
- 2 DEA, 1 FIRMS
- State
- NSW
- Confirmation
- Official
- Data source
- DEA,FIRMS
Burnt area & fire boundaries
Official mapped boundaries overlapping this fire — the ground it has burned. These are drawn on the map above (the shaded red areas). Boundaries are captured periodically, so the true edge may have moved since.
- OGILVIE RD, TABULAM
Official incident details
- Warning level
- Advice
- Type
- Bush Fire
- Status
- Under control
- Reported size
- 2,587 ha
- Agency
- NSW RFS
- Updated
LOCATION: Western end of Ogilvie Drive, TABULAM 2469
COUNCIL AREA: Tenterfield
STATUS: Under control
TYPE: Bush Fire
FIRE: Yes
SIZE: 2587 ha
RESPONSIBLE AGENCY: Rural Fire Service
UPDATED: 2 Oct 2026 08:34
Crew, appliance and aircraft numbers aren't published in Australia's open incident feeds, so we can't list firefighters here — follow the official source above for operational detail.
Satellite detections — 3 hot spots
This fire is 3 satellite heat detections merged into one event across 1 day (2 DEA, 1 FIRMS). Each row is one satellite pass over a burning pixel — all of them are plotted on the map above, where the most recent detections are ringed in white. Tap any point on the map for its time and intensity, or switch on the heat map (top-right) to see where activity concentrated.
| Time (UTC) | Intensity | Source | Latitude, Longitude |
|---|---|---|---|
| 1 Oct 2026, 03:32 | 3 MW | FIRMS | -28.994, 152.465 |
| 1 Oct 2026, 03:31 | 3 MW | DEA | -28.994, 152.465 |
| 1 Oct 2026, 03:31 | 3 MW | DEA | -28.994, 152.465 |
Other fires nearby
- TenterfieldNew South Wales✓ Confirmed4 km0 MW264 d ago
- TenterfieldNew South Wales✓ Confirmed11.7 km0 MW264 d ago
- Clarence ValleyNew South Wales✓ Confirmed16.4 km40 MW11 h ago
- Clarence ValleyNew South Wales✓ Confirmed17 km0 MW234 d ago
- Clarence ValleyNew South Wales✓ Confirmed26.1 km0 MW234 d ago
- Clarence ValleyNew South Wales✓ Confirmed26.3 km0 MW234 d ago
This satellite fire has been matched to an official incident (see the warning above). The official advice is the authority — always follow your fire agency, and in an emergency call 000.
Official information for NSW: NSW Rural Fire Service.
Get alerts for this fire · All current fires
Frequently asked questions
Is this a real bushfire?
Unless it is marked as matched to an official incident, this is an unconfirmed satellite detection. Satellites detect heat, which can be a bushfire, a hazard-reduction burn or an industrial source. Check the official warnings for confirmation.
What does “peak intensity (FRP)” mean?
FRP (fire radiative power, in megawatts) is how much heat the fire was giving off when a satellite detected it. The peak is the highest reading across all detections — a rough guide to how intense the fire has been.
Why are several nearby detections shown as one fire?
We group satellite detections that are close together in space and time into a single fire event, so a fire front seen across multiple passes appears as one fire rather than scattered dots.
How do I get the official information for this fire?
Follow the official source link on this page (where available) and your state fire agency. In an emergency call 000.